DeslicebetaES

Filament › Filament› Print temperaturechamber_temperatures

Chamber temperature

Higher chamber temperature can help suppress or reduce warping and potentially lead to higher interlayer bonding strength for high temperature materials like ABS, ASA, PC, PA and so on.At the same time, the air filtration of ABS and ASA will get worse.While for PLA, PETG, TPU, PVA and other low temperature materials,the actual chamber temperature should not be high to avoid cloggings, so 0 which stands for turning off is highly recommended

Not shown with the A1. Bambu Studio hides this setting when the printer can't use it. The A1 is open (no heated chamber or air filtration), has a single extruder, no fast purge and no prime tower interface layer. It shows up with printers that have them.
This page isn’t written yet. Above is the official Bambu Studio description; the plain-words explanation, the interactive example and the typical values will come later.

Setting details

Where it is
Filament › Filament › Print temperature
In the factory profile
0 °C
Type
Ints
Unit
°C
Range
0 – 80

Read more at the official source

This setting on the Bambu Lab wiki
In your profileBambu PLA Basic @BBL A1 · 0 °C

In Bambu Studio, the profile Bambu PLA Basic @BBL A1 sets it to0 °C

Using another slicer? Look for the idea, not the name: in Orca Slicer almost everything has the same name; in PrusaSlicer or Cura it may be called something else, or not exist.