DeslicebetaES

Process › Others› Prime towerprime_tower_fillet_wall

Fillet wall

Rounds the corners of the prime tower's wall so the nozzle can go around them without slamming on the brakes.

Not always visible. In Bambu Studio this setting only shows up when “Enable” is on and “Rib wall” is on. See Enable, Rib wall.

How it works

At a sharp corner, the print head has to stop and turn, and a little plastic piles up at that spot. With a rounded corner, the nozzle curves through at a steady speed and the wall comes out more even.

It's a detail: it affects how clean the tower looks, not what it does.

When to change it

  • For any print with a tower, from a two-color keychain to a multicolor figure: on, as it comes by default.
  • There's no common reason to turn it off.

Typical values

ValueWhat for
OnDefaultdefault
OffSharp corners

Watch out for

  • It only exists with “Rib wall” turned on. In the Spanish version of the program it shows up as “Pared de filete”.

Goes well with

Rib wall
What Bambu Studio saysits help card, quoted

What Bambu Studio says

The wall of prime tower will fillet

Bambu Studio tooltip for this setting · AGPL-3.0

Read more at the official source

This setting on the Bambu Lab wiki
In your profile0.20mm Standard @BBL A1 · Yes

In Bambu Studio, the profile 0.20mm Standard @BBL A1 sets it toYes

In other slicers

Orca Slicer
Fillet wallMultimaterial › Prime tower
PrusaSlicer
No clear equivalent.
Cura
No clear equivalent.

Names taken from each program's code (Orca Slicer 2.4.2, PrusaSlicer 2.9.6, Cura 5.13.0). Credits