DeslicebetaES

Process › Speed› Other layers speedslowdown_end_height

Ending height

The height at which the final speed cap is reached; above it, that cap stays in place. It must be greater than the starting height.

Not always visible. In Bambu Studio this setting only shows up when “Slow down by height” is on. See Slow down by height.

How it works

Between the starting height and this one, speed and acceleration drop in a straight line. At 400 mm (the factory value) the ramp is so long it barely slows anything; for a 200 mm tower it's best to enter its actual height here.

When to change it

  • A 200 mm tower: enter 200 mm, or the height above which you want the strongest slowdown.

Typical values

ValueWhat for
400Default; very long rampdefault
200200 mm tower

Watch out for

  • If it's lower than or equal to the starting height, the slowdown doesn't work.
  • It only shows up with “Slow down by height” turned on.

Goes well with

Slow down by heightStarting heightSpeed at ending height
What Bambu Studio saysits help card, quoted

What Bambu Studio says

The height finishes slowing down, Ending height should be larger than Starting height, or the slowing down will not work!

Bambu Studio tooltip for this setting · AGPL-3.0

Read more at the official source

Bambu Lab wiki (index)
In your profile0.20mm Standard @BBL A1 · 400 mm

In Bambu Studio, the profile 0.20mm Standard @BBL A1 sets it to400 mm

Using another slicer? Look for the idea, not the name: in Orca Slicer almost everything has the same name; in PrusaSlicer or Cura it may be called something else, or not exist.