DeslicebetaES

Process › Quality› Seamseam_slope_entire_loop

Scarf around the entire loop

Stretches the scarf ramp over the whole loop instead of a few millimeters. It's rarely worth it.

How it works

Instead of a short ramp, the whole loop is printed as a gentle spiral: it starts low and ends high. It sounds nice, but it means the entire loop gets less plastic than normal.

With this turned on, “Scarf length” is ignored.

When to change it

  • A small cup or a plain ring where you want to test whether the seam disappears completely: turn it on just to experiment. Bambu Lab advises caution.
  • Any other print: leave it off.

Typical values

ValueWhat for
NoDefault; short rampdefault
YesWhole loop as a ramp

Watch out for

  • With less plastic along the whole loop, lines may not bond well and the surface can show defects.

Goes well with

Scarf seam typeScarf length
What Bambu Studio saysits help card, quoted

What Bambu Studio says

The scarf extends to the entire length of the wall.

Bambu Studio tooltip for this setting · AGPL-3.0

Read more at the official source

This setting on the Bambu Lab wiki
In your profile0.20mm Standard @BBL A1 · No

In Bambu Studio, the profile 0.20mm Standard @BBL A1 sets it toNo

In other slicers

Orca Slicer
Scarf around entire wallQuality › Seam
PrusaSlicer
Scarf joint around entire perimeterLayers and perimeters › Advanced
Cura
No clear equivalent.

Names taken from each program's code (Orca Slicer 2.4.2, PrusaSlicer 2.9.6, Cura 5.13.0). Credits