Filament › Filament› Filament scarf seam settingsfilament_scarf_gap
Filament scarf slope gap
How much the inner and outer walls are shortened at the scarf seam, so it shows less.
How it works
It's the same scarf seam as in the Process tab (Quality › Seam), but stored in the filament profile: that way each material can bring its own scarf. If “Override filament scarf seam setting” is on in Process, Process wins and this is ignored.
When to change it
- Almost never: keep the profile's value and tune the seam in Process.
Typical values
| Value | What for |
|---|---|
| 0 | PLA Basicdefault |
Watch out for
- Only used if the filament scarf seam type isn't “None”.
Goes well with
What Bambu Studio saysits help card, quoted
What Bambu Studio says
In order to reduce the visiblity of the seam in closed loop, the inner wall and outer wall are shortened by a specified amount.
Bambu Studio tooltip for this setting · AGPL-3.0
Read more at the official source
In your profileBambu PLA Basic @BBL A1 · 0%
In Bambu Studio, the profile Bambu PLA Basic @BBL A1 sets it to0%
Using another slicer? Look for the idea, not the name: in Orca Slicer almost everything has the same name; in PrusaSlicer or Cura it may be called something else, or not exist.