Filament › Filament› Filament scarf seam settingsfilament_scarf_height
Filament scarf start height
At what height the scarf ramp starts, in millimeters or as a percentage of the layer height.
How it works
It's the same scarf seam as in the Process tab (Quality › Seam), but stored in the filament profile: that way each material can bring its own scarf. If “Override filament scarf seam setting” is on in Process, Process wins and this is ignored.
When to change it
- Almost never: keep the profile's value and tune the seam in Process.
Typical values
| Value | What for |
|---|---|
| 10% | PLA Basicdefault |
Watch out for
- Only used if the filament scarf seam type isn't “None”.
Goes well with
What Bambu Studio saysits help card, quoted
What Bambu Studio says
This amount can be specified in millimeters or as a percentage of the current layer height.
Bambu Studio tooltip for this setting · AGPL-3.0
Read more at the official source
In your profileBambu PLA Basic @BBL A1 · 10%
In Bambu Studio, the profile Bambu PLA Basic @BBL A1 sets it to10%
Using another slicer? Look for the idea, not the name: in Orca Slicer almost everything has the same name; in PrusaSlicer or Cura it may be called something else, or not exist.