Process › Speed› Other layers speedslowdown_end_speed
Speed at ending height
The speed cap when the height slowdown ends. It's the speed used for the tallest part of the print: lower means fewer ripples at the top.
Not always visible. In Bambu Studio this setting only shows up when “Slow down by height” is on. See Slow down by height.
How it works
It's the end of the ramp: above the ending height, nothing goes faster than this. For a thin tower, 60–100 mm/s at the top prevents ripples and shifted layers.
When to change it
- A very thin tower or a figure with tall, slender parts, like a sword or an antenna: 50–80 mm/s.
- A part that's tall but sturdy, like a wide vase: 120–150 mm/s.
Typical values
| Value | What for |
|---|---|
| 1000 | Default; no limitdefault |
| 80 | Top printed calmly |
Watch out for
- It only shows up with “Slow down by height” turned on.
Goes well with
What Bambu Studio saysits help card, quoted
Read more at the official source
In your profile0.20mm Standard @BBL A1 · 1000 mm/s
In Bambu Studio, the profile 0.20mm Standard @BBL A1 sets it to1000 mm/s
Using another slicer? Look for the idea, not the name: in Orca Slicer almost everything has the same name; in PrusaSlicer or Cura it may be called something else, or not exist.