Filament › Filament› Basic informationfilament_cooling_before_tower
Cooling before tower
How many degrees the nozzle drops when heading to the prime tower; before wiping, it heats back up. In PLA Basic it's 0: off.
How it works
With several filaments, the nozzle visits the prime tower on every change. With a value above 0, it drops that many degrees to ooze less on the way and returns to its temperature before wiping on the tower.
When to change it
- PLA: 0, as it comes.
- It only matters if you print with several filaments and a prime tower.
Typical values
| Value | What for |
|---|---|
| 0 °C | PLA Basic, offdefault |
Watch out for
- Only shown with Develop mode turned on in Preferences.
Goes well with
What Bambu Studio saysits help card, quoted
What Bambu Studio says
Temperature drop before entering filament tower
Bambu Studio tooltip for this setting · AGPL-3.0
Read more at the official source
In your profileBambu PLA Basic @BBL A1 · 0 °C
In Bambu Studio, the profile Bambu PLA Basic @BBL A1 sets it to0 °C
Using another slicer? Look for the idea, not the name: in Orca Slicer almost everything has the same name; in PrusaSlicer or Cura it may be called something else, or not exist.