DeslicebetaES

Process › Others› Special modefuzzy_skin_first_layer

Fuzzy skin on the first layer

Apply the texture to the first layer too. It's usually left smooth so it sticks well to the plate.

Not always visible. In Bambu Studio this setting only shows up when “Fuzzy Skin” is not “None(allow paint)”. See Fuzzy Skin.

How it works

The first layer is squashed against the plate and is what holds the part down. With texture, its outer wall jitters and sticks less well. That's why it's off by default: the texture starts on the second layer, leaving a one-layer smooth band at the base.

If that smooth band bothers you and the part sticks well to the plate, turn it on.

When to change it

  • A figure on a base: off (default).
  • A planter or box whose bottom edge is visible and should have the same texture: turn it on, as long as the first layer sticks well.

Typical values

ValueWhat for
OffDefaultdefault
OnEven texture down to the base

Watch out for

  • Only shows up with fuzzy skin turned on.

Goes well with

Fuzzy SkinInitial layer height
What Bambu Studio saysits help card, quoted

What Bambu Studio says

Whether to apply fuzzy skin on the first layer.

Bambu Studio tooltip for this setting · AGPL-3.0

Read more at the official source

This setting on the Bambu Lab wiki
In your profile0.20mm Standard @BBL A1 · No

In Bambu Studio, the profile 0.20mm Standard @BBL A1 sets it toNo

In other slicers

Orca Slicer
Apply fuzzy skin to first layerOthers › Fuzzy Skin
PrusaSlicer
No clear equivalent.
Cura
No clear equivalent.

Names taken from each program's code (Orca Slicer 2.4.2, PrusaSlicer 2.9.6, Cura 5.13.0). Credits