Detect narrow internal solid infill

How it works

Regular internal solid infill runs in parallel lines. In a narrow strip that turns into dozens of two-millimeter lines with a turn at each end: slow, with lots of starts and stops. With this option the slicer spots those strips and fills them by following their outline, with rings that go around them in one pass.

It only affects internal solid infill, the part you can't see. It comes turned on from the factory.

When to change it

• Almost always: leave it on. On parts with narrow solid strips, like a picture frame or the arms of a bracket, it saves time without showing on the outside.
• Turn it off only if, on a specific part, the rings leave a tiny gap in the middle of the strip and you'd rather have lines.

Typical values

Watch out for

Goes well with

Read more at the official source