DeslicebetaES

Filament › Filament› Basic informationfilament_adhesiveness_category

Adhesiveness category

A group number the prime tower uses to keep apart filaments that don't stick to each other.

How it works

The prime tower is built in sectors. Filaments in the same category share a sector, because they bond well with each other; those in different categories go in separate sectors, so the tower doesn't come apart inside.

Each filament's profile sets it; PLAs share a category.

When to change it

  • Don't touch it: the profile sets it.
  • It only matters if you print with several filaments and a prime tower.

Typical values

ValueWhat for
100PLA Basicdefault

Watch out for

  • Only shown with Develop mode turned on in Preferences.

Goes well with

Enable
What Bambu Studio saysits help card, quoted

What Bambu Studio says

Filament category

Bambu Studio tooltip for this setting · AGPL-3.0

Read more at the official source

This setting on the Bambu Lab wiki
In your profileBambu PLA Basic @BBL A1 · 100

In Bambu Studio, the profile Bambu PLA Basic @BBL A1 sets it to100

In other slicers

Orca Slicer
Adhesiveness CategoryFilament › Basic information
PrusaSlicer
No clear equivalent.
Cura
No clear equivalent.

Names taken from each program's code (Orca Slicer 2.4.2, PrusaSlicer 2.9.6, Cura 5.13.0). Credits