Filament › Advanced› Filament end G-codefilament_end_gcode
Filament end G-code
Commands the printer runs when it finishes printing with this filament.
How it works
Like the start block, but when this filament leaves: when switching to another or at the end of the print. In PLA Basic it's practically empty.
When to change it
- Almost never: leave it as it comes.
Typical values
| Value | What for |
|---|---|
| (almost empty) | PLA Basicdefault |
Watch out for
- A wrong command here affects every print with this filament, without warning.
Goes well with
What Bambu Studio saysits help card, quoted
What Bambu Studio says
End G-code when finish the printing of this filament
Bambu Studio tooltip for this setting · AGPL-3.0
Read more at the official source
In your profileBambu PLA Basic @BBL A1 · ; filament end gcode
In Bambu Studio, the profile Bambu PLA Basic @BBL A1 sets it to; filament end gcode
In other slicers
- Orca Slicer
- End G-codeAdvanced › Filament end G-code
- PrusaSlicer
- End G-codeCustom G-code › End G-code
- Cura
- No clear equivalent.
Names taken from each program's code (Orca Slicer 2.4.2, PrusaSlicer 2.9.6, Cura 5.13.0). Credits